How to use FAS against bedbugs? - briefly
Apply the FAS aerosol directly to mattress seams, bed frames, and cracks where bedbugs conceal themselves, covering all affected surfaces and allowing the spray to dry as specified; repeat the application after 7–10 days to eliminate any newly hatched insects.
How to use FAS against bedbugs? - in detail
FAS, a fast‑acting spray formulated for domestic pest control, can eradicate bedbug infestations when applied correctly. The procedure consists of preparation, application, and post‑treatment measures.
Begin by removing clutter from the sleeping area. Launder all bedding, curtains, and clothing at the highest temperature the fabric tolerates; dry‑heat cycles of at least 60 °C are optimal. Vacuum mattresses, box springs, and surrounding furniture, discarding the vacuum bag or cleaning the canister immediately to prevent re‑infestation.
Inspect the mattress seams, headboard, and bed frame for live insects and eggs. Mark these zones with tape to ensure thorough coverage. Ensure the room is well‑ventilated but free of open windows during spraying to maintain aerosol concentration.
Apply the FAS product as follows:
- Shake the canister for 30 seconds to mix the propellant and active ingredients.
- Hold the nozzle 6–12 inches from the surface; maintain a steady back‑and‑forth motion.
- Spray each identified zone with a light, even mist, covering seams, cracks, and crevices.
- Extend the spray to adjacent baseboards, floorboards, and any furniture within a 3‑foot radius.
- Avoid oversaturation; excess liquid can damage fabrics and reduce efficacy.
After treatment, seal the room for the duration specified on the label, typically 2–4 hours, to allow the aerosol to act on all life stages. Use fans to circulate air if recommended by the manufacturer. Once the exposure period ends, ventilate the space by opening windows and running an exhaust fan for at least 30 minutes.
Finally, repeat the entire process after seven days to target newly hatched nymphs that survived the initial application. Continue monitoring with sticky traps or visual inspections weekly for at least one month. If activity persists, a second full‑cycle treatment may be necessary, followed by professional assessment.