How to use BarS for bedbugs? - briefly
Apply BarS directly to all infested surfaces—mattress seams, bed frames, cracks, and crevices—and allow it to dry completely; repeat the application after 7–10 days to eliminate newly emerged bugs. Use a calibrated sprayer to ensure even coverage and follow the product’s safety guidelines for ventilation and protective gear.
How to use BarS for bedbugs? - in detail
BarS is a silicate‑based insecticide designed to eliminate Cimex lectularius infestations through direct contact and residual action. Begin by preparing the treatment area: remove bedding, curtains, and fabric items; wash them in hot water (≥ 60 °C) and dry on high heat. Vacuum mattresses, box springs, and surrounding furniture, discarding the vacuum bag or cleaning the canister immediately to prevent re‑distribution of insects.
Mix the concentrate according to the manufacturer’s label, typically one part BarS to nine parts water. Use a low‑pressure spray gun or a pump‑up sprayer to apply a fine mist. Target the following zones:
- seams, tufts, and folds of mattresses and pillows
- cracks and crevices in headboards, footboards, and bed frames
- baseboard joints, wall–floor intersections, and behind wall hangings
- under furniture legs and inside drawer slides
Maintain a wet film for at least 10 minutes before allowing the surface to dry. Re‑apply to the same locations after 7 days to address newly hatched nymphs that survived the initial exposure.
After treatment, replace cleaned bedding and re‑install furniture. Monitor for live insects weekly; a decline to zero within three weeks indicates successful control. If activity persists, repeat the spray cycle once more, ensuring thorough coverage of missed micro‑habitats. Use personal protective equipment (gloves, goggles, mask) throughout the process to avoid skin irritation and inhalation of aerosol particles.