How to dilute Fitoverm for treating cucumbers from spider mite if 2 ml is required? - briefly
Mix 2 ml of Fitoverm with 10 L of clean water, stirring until evenly distributed; apply the solution to cucumber foliage until runoff. Use the same concentration for each treatment session.
How to dilute Fitoverm for treating cucumbers from spider mite if 2 ml is required? - in detail
When the label indicates that 2 ml of Fitoverm concentrate is needed for cucumber spider‑mite control, the mixture must be prepared with precise water volume to achieve the recommended concentration.
First, check the product label for the target dilution rate, typically expressed as milliliters of concentrate per liter of water. If the label specifies 2 ml per 10 L, use that ratio; if it provides a different proportion, adjust accordingly. The calculation is straightforward: multiply the required amount of concentrate (2 ml) by the factor that converts it to the volume of water indicated on the label.
Example calculation (2 ml per 10 L):
- Desired water volume = 10 L
- Add 2 ml of Fitoverm to the 10 L of water.
If the label states 2 ml per 5 L, the required water volume is 5 L. Use the same method for any other ratio.
After determining the correct water amount, follow these steps:
- Fill a clean spray tank with the measured volume of water. Use room‑temperature water to ensure even mixing.
- Add the 2 ml of Fitoverm concentrate to the water. Pour the concentrate slowly to avoid splashing.
- Close the tank and agitate gently for 30–60 seconds. This ensures the active ingredient is uniformly distributed.
- Allow the mixture to stand for a few minutes to let any foam dissipate.
- Apply the solution to cucumber foliage, covering both upper and lower leaf surfaces where spider mites reside. Use a fine‑mist setting for thorough coverage.
- Observe the manufacturer's recommended re‑application interval, often 7–10 days, and repeat the process if infestation persists.
Safety precautions are essential:
- Wear gloves, goggles, and long sleeves during mixing and application.
- Avoid contact with skin and eyes; wash hands thoroughly after handling.
- Do not spray in windy conditions to prevent drift onto non‑target plants.
- Store any unused concentrate in its original container, tightly sealed, and out of reach of children and animals.
Temperature and pH can affect efficacy. Apply when ambient temperature is between 15 °C and 30 °C, and avoid direct sunlight during the first hour after spraying to reduce rapid degradation of the active ingredient.
By adhering to these precise measurements and procedural steps, the dilution of Fitoverm for cucumber spider‑mite management will meet label specifications and maximize pest control effectiveness.