How to put on a flea and tick collar made of wormwood? - briefly
Place the collar around the animal’s neck, positioning it just below the jawline so it is snug yet allows two fingers to slide underneath, then trim any excess to prevent slipping. Verify the fit each day and replace the device according to the producer’s recommended schedule.
How to put on a flea and tick collar made of wormwood? - in detail
Applying a wormwood‑infused flea and tick collar correctly ensures maximum protection and comfort for the animal.
First, verify that the collar size matches the pet’s neck circumference. Measure the neck, add a few centimeters for adjustment, and select the corresponding size indicated by the manufacturer.
Second, inspect the collar for any damage or residue. If the material appears torn or the wormwood coating is uneven, discard it and use a new one.
Third, place the collar around the neck, positioning the protective side outward. The side containing the wormwood extract should face away from the skin to prevent irritation, while the inner side should rest gently against the fur.
Fourth, secure the fastening mechanism:
- Slide the clasp or buckle over the collar.
- Pull the strap until a snug but not tight fit is achieved; you should be able to insert two fingers between the collar and the neck.
- Lock the buckle or snap the clasp firmly, ensuring no slack.
Fifth, observe the pet for a short period after fitting. Check for signs of discomfort, excessive scratching, or breathing difficulty. If any adverse reaction occurs, remove the collar immediately and consult a veterinarian.
Finally, maintain the collar by:
- Cleaning the outer surface with a damp cloth as needed.
- Replacing the collar according to the product’s recommended lifespan, typically every 30–45 days, because the efficacy of the wormwood compounds diminishes over time.
Following these steps guarantees proper installation and optimal performance of a wormwood‑based flea and tick collar.