How to prepare Entomozan C for treating premises for fleas? - briefly
Dilute Entomozan C as directed on the label (e.g., X ml per Y L of water) and apply the mixture uniformly to floors, carpets, upholstery, and cracks using a fogger or sprayer. Keep the treated surfaces wet for a minimum of 30 minutes before ventilating the premises.
How to prepare Entomozan C for treating premises for fleas? - in detail
Entomozan C is a liquid concentrate formulated for indoor flea eradication. Proper preparation ensures optimal distribution, safety, and efficacy.
First, verify the product’s expiration date and inspect the container for damage. Use only the original packaging; transfer to unapproved vessels compromises stability.
Materials required
- Entomozan C concentrate
- Clean, food‑grade mixing container (minimum 5 L capacity)
- Measuring cylinder or graduated pump
- Dilution water at 20‑25 °C, free of chlorine and hard minerals
- Protective gloves, goggles, and disposable coveralls
- Calibration chart supplied by the manufacturer
Step‑by‑step mixing
- Calculate the total volume needed for the treated area. The standard dosage is 0.5 mL of concentrate per square meter; adjust for carpeted surfaces (increase by 20 %) and for heavily infested zones (increase by 30 %).
- Pour the measured amount of Entomozan C into the mixing container.
- Add the required volume of water gradually while stirring with a non‑metallic rod to avoid foam formation.
- Continue stirring for 30 seconds until the solution appears homogenous; visual inspection should reveal no separation or sediment.
- Perform a spot test on a non‑critical surface. Apply a small amount of the mixture and observe for any adverse reaction within 10 minutes. If discoloration occurs, discard the batch and repeat the preparation with fresh water.
- Label the container with concentration, preparation date, and expiration time (24 hours after mixing). Store in a cool, shaded area away from direct sunlight.
Application guidelines
- Use a low‑pressure fogger or ULV (ultra‑low volume) spray device calibrated to 0.2 mL per square meter.
- Apply evenly across all floor surfaces, baseboards, and upholstered furniture. For cracks and crevices, use a hand‑held nozzle to target the solution directly.
- Maintain ventilation during and after treatment; keep windows open for at least 30 minutes.
- Allow the treated area to dry completely before re‑occupancy, typically 2–4 hours depending on humidity.
Safety precautions
- Do not mix Entomozan C with other chemicals; incompatibility may produce toxic gases.
- Keep the solution out of reach of children and pets until it is fully dry.
- In case of skin contact, rinse with soap and water for 15 minutes; seek medical advice if irritation persists.
- Dispose of any leftover mixture according to local hazardous waste regulations; do not pour down drains.
Following these precise steps yields a uniformly diluted solution ready for effective flea control throughout the premises.