How to dilute fufanon for bedbugs? - briefly
Mix fufanon with water at a 1 : 10 volume ratio and spray the solution directly onto bed‑bug habitats; allow it to remain wet for at least 10 minutes before wiping or vacuuming. Use a fine mist applicator to ensure even coverage and avoid excessive runoff.
How to dilute fufanon for bedbugs? - in detail
Fufanon is a pyrethroid‑based concentrate supplied at 10 % active ingredient. Effective control of Cimex lectularius requires a working solution of approximately 0.1 % concentration. The reduction factor is therefore 1 : 100, meaning one part concentrate must be combined with 99 parts water.
Safety measures precede any preparation. Personal protective equipment—gloves, goggles, and a mask—must be worn. The mixture should be prepared in a well‑ventilated area, away from open flames or sparks.
Calculation steps
- Measure 10 ml of concentrate.
- Add 990 ml of cold, de‑chlorinated water.
- Stir gently for 30 seconds to ensure uniform distribution.
Mixing procedure
- Pour the measured water into a clean, chemically resistant container.
- Introduce the concentrate slowly, allowing it to flow down the side of the vessel.
- Close the container and invert three times; avoid vigorous shaking to prevent foaming.
- Label the solution with concentration, preparation date, and hazard warnings.
Application guidelines specify a spray volume of 0.5 ml per square foot of infested surface. Apply evenly to cracks, crevices, and the undersides of furniture. Allow the treated area to remain wet for at least 10 minutes before vacuuming or wiping.
The prepared solution remains potent for 24 hours when stored in a sealed, opaque container at temperatures between 5 °C and 25 °C. Discard any unused mixture after this period; do not pour it down drains. Use a certified hazardous waste service for disposal.