How to dilute Creolin for treating a dog's fleas? - briefly
Mix one part Creolin with nine parts water (approximately a 1:10 dilution), stir thoroughly, apply to the dog's fur with a spray bottle, leave for 10‑15 minutes, then rinse completely.
How to dilute Creolin for treating a dog's fleas? - in detail
Creolin must be mixed with water before it is applied to a dog for flea control. Use a clean container, add the measured amount of the concentrate, then slowly incorporate the required volume of lukewarm water while stirring to achieve a uniform solution.
- Determine the concentration recommended by the product label; typical dilution ratios range from 1 % to 5 % (1 ml of Creolin per 100 ml of water for a 1 % solution, up to 5 ml per 100 ml for a 5 % solution).
- Measure the exact volume of concentrate with a calibrated syringe or graduated cylinder.
- Pour the measured Creolin into a bucket, then add the calculated amount of water.
- Stir gently for 30–60 seconds until the mixture appears clear and no clumps remain.
- Allow the solution to stand for a few minutes to eliminate any foam that may form.
Application guidelines:
- Test the diluted solution on a small area of the dog’s skin before full use; observe for any adverse reaction within 15 minutes.
- Apply the solution with a spray bottle or a damp cloth, thoroughly wetting the coat but avoiding excessive runoff.
- Focus on areas where fleas are most active: neck, base of the tail, underbelly, and between the toes.
- Do not apply directly to the eyes, nose, or open wounds.
- After treatment, keep the dog in a well‑ventilated area until the coat dries.
Safety precautions:
- Wear gloves and protective eyewear while handling the concentrate.
- Keep the mixture away from children and other pets.
- Store the undiluted product in a locked cabinet, out of direct sunlight, at temperatures between 10 °C and 30 °C.
- Dispose of any leftover solution according to local hazardous‑waste regulations; do not pour large volumes down household drains.
Repeat the treatment according to the schedule indicated on the label, usually every 7–10 days, until the flea population is eliminated. Monitor the dog’s condition throughout the process; discontinue use and consult a veterinarian if signs of irritation, excessive salivation, or lethargy appear.