How should butox be mixed for fleas? - briefly
Mix 0.5 ml of butox concentrate into 1 liter of lukewarm water, stirring until the solution is uniform; apply the mixture to the animal’s coat and surrounding areas, avoiding eyes and open wounds. Use the diluted solution within 24 hours for optimal flea control.
How should butox be mixed for fleas? - in detail
When preparing a butox solution for flea control, follow a precise protocol to ensure efficacy and safety.
First, select the appropriate concentration. The label typically recommends a 0.5 % to 1 % active ingredient mixture for indoor environments. For a 1 % solution, dissolve 10 g of pure butox in 1 L of water; for 0.5 %, use 5 g per liter. Adjust volume according to the total area to be treated, maintaining the same ratio.
Second, use a compatible diluent. Warm (not hot) tap water, at about 25 °C, promotes complete dissolution. Add the measured butox powder to the water gradually while stirring continuously with a non‑metallic rod. Avoid adding water to the powder; introduce the powder into the water to prevent clumping.
Third, ensure thorough mixing. Continue agitation for at least two minutes until the solution appears clear and no sediment remains. A handheld drill with a mixing attachment can provide consistent agitation for larger batches.
Fourth, verify the mixture. Use a calibrated test strip or a spectrophotometric method to confirm the concentration falls within the target range. Record the result in a logbook.
Fifth, apply the solution promptly. Transfer the prepared liquid to a clean spray bottle equipped with a fine‑mist nozzle. Apply evenly across carpets, upholstery, and cracks where fleas hide, maintaining a wet surface for 10–15 minutes before allowing it to dry. Do not exceed the recommended coverage per litre, typically 10 m².
Safety considerations:
- Wear disposable gloves and eye protection during preparation.
- Store any unused solution in a sealed, labeled container, away from children and pets, for no longer than 24 hours.
- Dispose of empty containers according to local hazardous waste regulations.
Cleaning the equipment after use prevents cross‑contamination. Rinse the spray bottle with water, then with a mild detergent solution, and finally with clean water. Allow it to air‑dry before the next preparation.
By adhering to these steps, the butox mixture will achieve optimal flea eradication while minimizing risks to humans and animals.