How should BarS be properly used against ticks? - briefly
Apply BarS to the animal’s skin and coat, covering all potential attachment sites, and repeat the treatment at the interval specified on the label, usually every 30 days. Observe the recommended dosage and any required withdrawal period before slaughter.
How should BarS be properly used against ticks? - in detail
BarS is a synthetic acaricide formulated for direct contact and systemic action against tick populations. Effective deployment requires strict adherence to dosage, timing, application technique, and safety protocols.
-
Dosage calculation: Determine the target species, life stage, and infestation density. Apply the product at the label‑specified concentration, typically expressed in milligrams of active ingredient per square meter or per kilogram of host weight. Use calibrated sprayers or calibrated feed mixers to ensure uniform distribution.
-
Application timing: Treat hosts during peak questing periods, usually early spring and late summer, when ticks are actively seeking blood meals. Re‑treat at intervals matching the residual activity period indicated on the label, commonly every 2–4 weeks for sustained protection.
-
Method of delivery:
- Topical spray: Cover the entire body surface of the animal, paying special attention to folds, ears, and tail base. Maintain a wet film for at least 30 seconds before allowing the animal to move.
- Pour‑on: Apply a measured volume along the dorsal midline, allowing the product to spread caudally by natural grooming.
- Oral administration: Mix the precise amount into feed or water, ensuring complete ingestion. Verify that the feed intake meets the calculated dose per kilogram of body mass.
-
Safety measures: Wear chemical‑resistant gloves, goggles, and protective clothing. Avoid inhalation of aerosols; use a low‑pressure pump or a respirator equipped with organic vapor cartridges. Keep treated animals away from untreated livestock for at least 24 hours to prevent cross‑contamination.
-
Environmental considerations: Do not apply BarS near water bodies, drainage ditches, or on vegetation that may leach into runoff. Observe buffer zones of at least 10 meters from streams and ponds. Dispose of empty containers according to hazardous waste regulations.
-
Resistance management: Rotate BarS with acaricides of different mode of action on a quarterly basis. Record treatment dates, dosages, and observed efficacy to detect early signs of reduced susceptibility.
-
Monitoring and evaluation: Conduct tick counts before treatment, then at 7‑day intervals post‑application. Use standardized drag sampling or host inspection methods. Document mortality rates and adjust future applications based on observed control levels.
Following these procedures maximizes tick mortality while minimizing risks to animals, personnel, and the surrounding ecosystem.