How do you dilute Cifox 25 for tick control? - briefly
Combine 1 ml of Cifox 25 with 10 L of clean water to reach the label‑specified concentration for tick control, mixing thoroughly before use. Apply the solution evenly to the target area while wearing appropriate protective gear.
How do you dilute Cifox 25 for tick control? - in detail
To prepare a working solution of Cifox 25 for tick eradication, follow these precise steps.
-
Determine the target concentration. The label recommends a final strength of 0.25 g of active ingredient per liter of water for most livestock applications. Adjust upward to 0.35 g/L for heavy infestations, but do not exceed 0.5 g/L.
-
Measure the required amount of product. For a 10‑liter batch at 0.25 g/L, weigh 2.5 g of Cifox 25 powder. Use a calibrated scale; record the weight before mixing.
-
Fill a clean mixing tank with 8 L of warm (approximately 20 °C) water. Warm water improves solubility and reduces clumping.
-
Add the measured product to the water while stirring continuously with a paddle mixer or a low‑speed drill‑mounted stirrer. Continue agitation for at least 2 minutes until the powder dissolves completely and no visible particles remain.
-
Top up the mixture with an additional 2 L of water, maintaining gentle stirring throughout. Verify that the final volume is exactly 10 L.
-
Perform a quick visual inspection. The solution should be clear, without sediment. If cloudiness persists, increase stirring time by 30 seconds and re‑check.
-
Apply the solution promptly. Use a calibrated spray rig or a low‑pressure misting system set to deliver 2 L per 100 m² of animal housing. Ensure uniform coverage of the environment and the animals’ bodies.
-
Observe safety precautions. Wear chemical‑resistant gloves, goggles, and a disposable coverall. Avoid inhalation of aerosolized droplets. Keep the preparation away from open flames and oxidizing agents.
-
Record the batch details: date, concentration, total volume, and operator name. Store any unused product in its original container, tightly sealed, at a temperature below 25 °C, away from direct sunlight.
-
Dispose of rinse water according to local hazardous waste regulations. Rinse all equipment with fresh water after use and allow it to dry before storage.
By adhering strictly to these guidelines, the dilution process yields an effective concentration for tick control while minimizing the risk of under‑dosing or chemical exposure.