How to wash the floor to remove soil fleas? - briefly
Mix a strong detergent with hot water, scrub the floor thoroughly, rinse with clean water, and dry completely; repeat if any fleas remain. Vacuum and keep the surface dry afterward to prevent re‑infestation.
How to wash the floor to remove soil fleas? - in detail
To eradicate soil‑dwelling fleas from a hard surface, begin by isolating the area. Remove rugs, mats, and any loose debris; vacuum thoroughly using a brush‑roll attachment, then discard the bag or empty the canister into a sealed container.
Select a cleaning solution that combines a surfactant with an insecticidal ingredient approved for indoor use. Dilute the product according to the manufacturer’s instructions, ensuring the concentration is sufficient to penetrate the soil layer without damaging the flooring material.
Apply the mixture with a mop or a microfiber‑wrapped mop head. Work in sections no larger than one square meter, allowing the liquid to soak for two to three minutes so that it reaches the flea larvae and eggs embedded in the substrate. During this dwell time, gently scrub each section with a stiff‑bristled brush to dislodge organisms from crevices.
Rinse the floor with clean water, using a separate mop to remove residual chemicals. Extract excess moisture with a wet‑vacuum or a floor squeegee; rapid drying prevents re‑infestation. Ensure the surface reaches a humidity level below 50 % before allowing foot traffic.
After cleaning, implement preventive measures: keep the floor dry, seal cracks, and schedule regular vacuuming. If the problem recurs, repeat the treatment cycle after seven days to target any newly hatched fleas. Monitoring with a sticky trap placed near the cleaned area can confirm the effectiveness of the process.