How to mix entomozan for flea control? - briefly
Mix entomozan with warm water at a 1 part to 10 parts ratio, stirring until completely dissolved, then spray the solution onto pet bedding, carpets, and cracks where fleas hide. Keep the treated surfaces damp for 30 minutes before vacuuming to maximize efficacy.
How to mix entomozan for flea control? - in detail
Preparing an effective entomozan solution for flea control requires precise measurement, thorough mixing, and adherence to safety protocols.
Begin with personal protective equipment: gloves, goggles, and a mask. Ensure the work area is well‑ventilated and free of food or water sources that could become contaminated.
Calculate the required concentration according to the product label, typically expressed in milliliters per liter of water. Use a calibrated measuring device to withdraw the exact amount of concentrate.
Fill a clean container with the appropriate volume of lukewarm water. Add the measured entomozan slowly while stirring continuously. Stirring can be performed with a non‑metallic paddle or a mechanical stirrer set to low speed. Continue agitation for at least one minute to achieve a homogeneous mixture; visual inspection should reveal no undissolved particles.
Transfer the solution to a spray bottle or fogger compatible with the formulation. Label the container with concentration, preparation date, and hazard warnings.
Apply the mixture to infested areas following the label’s coverage guidelines. Target cracks, crevices, pet bedding, and carpet fibers. Maintain a wet surface for the contact time specified on the label, usually 10–15 minutes, before allowing drying.
Store any remaining solution in a tightly sealed, opaque container at a temperature between 5 °C and 25 °C. Discard unused concentrate after the manufacturer’s recommended shelf life expires.
Common issues and corrective actions:
- Separation after standing – remix briefly before each use.
- Reduced efficacy – verify concentration with a calibrated scale; adjust if deviation exceeds 5 %.
- Residue on surfaces – rinse with clean water if the label permits, or allow natural evaporation.
Regular monitoring of flea activity and reapplication according to the product’s re‑treatment interval ensure sustained control.