How to fasten a flea collar on a cat? - briefly
Slide the collar over the cat’s head and position it just behind the ears; adjust it until you can fit two fingers between the collar and the neck, then lock the fastener.
How to fasten a flea collar on a cat? - in detail
Begin by selecting a collar sized for the cat’s neck circumference. Measure the neck with a soft tape; the collar should be 1–2 cm longer than this measurement to allow adjustment.
- Open the clasp or fast‑enabling mechanism. Most flea collars use a sliding buckle or a snap‑type lock.
- Slip the collar over the cat’s head, positioning it just behind the ears. Ensure the cat is calm; a gentle hold or a treat can reduce resistance.
- Pull the free end of the collar until it rests snugly against the skin, leaving enough slack to insert one or two fingers between the collar and the neck. Excessive tightness can cause breathing difficulty or skin irritation.
- Secure the buckle:
- For a sliding buckle, align the metal bar with the slot and slide it into place, then press the locking tab.
- For a snap lock, press the two halves together until an audible click confirms closure.
- Verify the fit by feeling for any pinching points and confirming the cat can move its head freely. Adjust if necessary.
- After fitting, monitor the cat for the first 24 hours. Check for signs of discomfort, excessive scratching, or the collar sliding off. Re‑adjust as needed.
Additional considerations:
- Use a collar made from hypoallergenic material to minimize skin reactions.
- Replace the collar according to the product’s duration guidelines, typically every 30 days, even if the cat appears pest‑free.
- Keep the collar away from water sources that could degrade the insecticide coating; dry the cat after baths before re‑applying.
By following these precise steps, the flea‑preventive band remains effective while preserving the animal’s safety and comfort.