How to dilute Fitosverm for treating indoor plants against mites? - briefly
Mix 5 ml of Fitosverm concentrate with 1 L of water, stir, and spray the solution onto foliage until runoff, covering both leaf surfaces. Apply weekly until mites disappear, then switch to bi‑weekly maintenance.
How to dilute Fitosverm for treating indoor plants against mites? - in detail
To prepare an effective Fitosverm solution for indoor foliage affected by mites, follow a precise mixing protocol, observe safety measures, and apply the spray according to recommended intervals.
Measure the product accurately. The standard concentration for mite control is 5 ml of Fitosverm per 1 liter of water. For smaller plants, scale down proportionally (e.g., 2.5 ml per 500 ml). Use a calibrated syringe or graduated cylinder to avoid dosing errors.
Combine the measured amount with lukewarm water in a clean spray bottle. Stir gently; vigorous shaking can create foam that interferes with nozzle performance. Allow the mixture to rest for 5 minutes to ensure uniform distribution of the active ingredient.
Apply the solution directly to the undersides of leaves, where mites congregate. Ensure thorough coverage without runoff. Spray in the early morning or late afternoon to minimize plant stress and reduce evaporation. A single application is usually sufficient; repeat after 7–10 days if infestation persists.
Safety precautions:
- Wear gloves and eye protection during preparation.
- Keep the mixture away from children and pets.
- Store any unused solution in a sealed container, labeled, and discard after 24 hours to prevent degradation.
Record the date, concentration, and plant species for each treatment. This documentation supports consistent results and facilitates adjustments if mite pressure changes.