How to dilute Entomozan for treating a premises for fleas? - briefly
Mix 1 ml of Entomozan concentrate with 1 liter of clean water (approximately a 1:1000 dilution) and apply the solution evenly to all floor, carpet, and upholstery surfaces using a spray bottle or fogger. Ensure the treated area remains wet for at least 30 minutes before allowing normal use.
How to dilute Entomozan for treating a premises for fleas? - in detail
Entomozan is supplied as a concentrated liquid that must be mixed with water before it can be applied to an interior environment for flea eradication. The dilution process requires precise measurement, thorough mixing, and adherence to safety protocols.
First, gather the necessary tools: a calibrated measuring cup or graduated cylinder, a clean container with a capacity exceeding the final volume, a stirring rod or mechanical agitator, and personal protective equipment (gloves, goggles, mask). Verify that the container is free of residues that could react with the insecticide.
Next, determine the target concentration. The label recommends a working strength of 0.5 ml of product per 10 liters of water for indoor flea treatment. Adjust the volume proportionally if a larger or smaller batch is needed. For example:
Measure the exact amount of concentrate with the calibrated device. Slowly pour the measured liquid into the water container while stirring continuously. Add water first, then the concentrate, to ensure even distribution. Continue agitation for at least one minute until the mixture appears homogeneous and no visible separation remains.
Before application, inspect the solution for clarity. Any cloudiness or particulate matter indicates incomplete mixing and requires further agitation. Once the solution meets visual criteria, transfer it to a spray device equipped with a fine‑mist nozzle. Test the spray pattern on a disposable surface to confirm even coverage.
Apply the diluted product to all areas where fleas may reside: carpets, upholstery, cracks, and baseboards. Maintain a wet film for the contact time specified on the label, typically 10–15 minutes, before allowing the surface to dry. Avoid over‑saturation, which can cause runoff and increase exposure risk.
After treatment, dispose of any leftover solution according to local hazardous waste regulations. Clean all equipment with soap and water, then rinse thoroughly. Store the original Entomozan container in a locked, temperature‑controlled area, out of reach of unauthorized personnel and pets.