How to dilute Entomozan for tick control? - briefly
Mix the concentrate with water at the label‑recommended rate, typically 1 ml per litre for effective tick control. Stir well and apply evenly to vegetation, following all safety guidelines.
How to dilute Entomozan for tick control? - in detail
Entomozan must be mixed according to the label‑specified concentration for effective tick management. The recommended rate for most residential applications is 0.5 ml of concentrate per 10 L of water, delivering approximately 50 ppm of active ingredient. Adjust the ratio proportionally for larger volumes or higher infestation levels, but never exceed the maximum concentration listed on the product label.
Preparation steps
- Measure the required amount of concentrate with a calibrated syringe or graduated cylinder.
- Add the measured dose to a clean container.
- Fill the container with the appropriate volume of clean water, stirring continuously to ensure uniform dispersion.
- Allow the mixture to stand for 2–3 minutes to eliminate foam and verify complete dissolution.
- Transfer the solution to a calibrated sprayer or fogger, checking that the equipment is calibrated to deliver the intended volume per hectare.
Safety and handling
- Wear chemical‑resistant gloves, goggles, and a respirator rated for aerosolized pesticides.
- Perform mixing in a well‑ventilated area away from open flames.
- Store unused concentrate in its original sealed container, protected from sunlight and temperatures above 30 °C.
- Dispose of rinse water according to local hazardous waste regulations.
Application guidelines
- Apply during low‑wind conditions (≤ 5 km/h) to minimize drift.
- Target the leaf litter, low vegetation, and animal bedding where ticks reside.
- Re‑treat at 7‑day intervals for a minimum of three applications during peak tick activity.
- Record application dates, rates, and weather conditions for future reference and compliance audits.
Troubleshooting
- If the solution appears cloudy, verify that the water is free of hard minerals; use deionized water if necessary.
- Inconsistent coverage may indicate a clogged nozzle; clean or replace the nozzle before resuming application.
- Reduced efficacy after repeated use can result from resistance development; rotate with a different class of acaricide according to integrated pest management recommendations.
Following these precise mixing and application procedures ensures that Entomozan delivers the intended acaricidal effect while maintaining compliance with safety and environmental standards.