How should you correctly apply drops to the shoulder area for ticks and fleas? - briefly
Apply the recommended number of drops directly onto the clean, dry skin over the shoulder blade, then gently massage the area to aid absorption. Observe the animal for any signs of irritation after treatment.
How should you correctly apply drops to the shoulder area for ticks and fleas? - in detail
Apply the product directly onto the animal’s shoulder, the site most commonly recommended for systemic ectoparasite treatments. Follow these steps precisely:
- Part the fur with a clean comb or your fingers to expose a small area of skin, approximately 2‑3 cm in diameter.
- Clean the exposed skin with a mild, alcohol‑free wipe to remove dirt or oil that could impede absorption. Allow it to dry for a few seconds.
- Measure the exact dose indicated on the label for the animal’s weight. Use the supplied dropper or syringe; do not guess the volume.
- Hold the dropper vertically above the skin, not at an angle, to ensure the liquid falls straight onto the surface.
- Release the measured drops in a single, steady stream onto the prepared spot. Avoid splashing onto surrounding fur or the animal’s eyes, nose, or mouth.
- After application, keep the animal from licking or rubbing the area for at least 5 minutes. If necessary, use a short‑term Elizabethan collar or monitor the animal closely.
- Dispose of any remaining product according to the manufacturer’s instructions and wash your hands thoroughly.
Repeat the procedure only if the label specifies a repeat dose, and always adhere to the recommended interval between treatments. Proper placement on the shoulder maximizes systemic absorption, delivering effective control of both ticks and fleas.