How should tick drops be used? - briefly
Apply a few drops of the tick‑removal solution directly onto the attached tick, wait the manufacturer’s specified time (typically 5–10 minutes) for the tick to become immobilized, then extract it with fine tweezers, pulling straight out to remove the mouthparts. Dispose of the tick and any remaining solution according to local waste guidelines.
How should tick drops be used? - in detail
Tick‑removal drops must be applied directly to the affected area after the tick has been detached. Use a sterile applicator to place the recommended amount of solution onto the bite site. Allow the liquid to soak the skin for at least two minutes before covering the area with a clean bandage.
The following protocol ensures optimal efficacy and safety:
- Verify the product’s concentration; most formulations contain 5‑10 % ivermectin or a comparable acaricide.
- Measure the dose according to the label: typically 0.5 ml for children and 1 ml for adults, adjusted for body weight when indicated.
- Apply the measured volume to the skin surrounding the puncture wound, avoiding direct contact with eyes, mucous membranes, or open lesions.
- Keep the treated region uncovered for 30 minutes to permit absorption; re‑apply only if instructed by a healthcare professional.
- Dispose of any used applicators in a sealed container to prevent accidental exposure.
Do not exceed the prescribed frequency; most products advise a single application, with a repeat dose after 24 hours only if symptoms persist. Monitor the site for signs of irritation, redness, or swelling. If adverse reactions occur, rinse the area with water and seek medical advice.
Storage requirements include a cool, dry environment away from direct sunlight. Keep the container tightly sealed and out of reach of children and pets. Expired or compromised products must be discarded according to local hazardous‑waste regulations.