How should entomozan be diluted for treating premises against ticks? - briefly
«Entomozan» should be diluted with water at a ratio of 1 ml per 10 liters, yielding a 0.01 % w/v solution for indoor tick control. Apply the solution evenly to all surfaces and let it dry completely before re‑entry.
How should entomozan be diluted for treating premises against ticks? - in detail
Entomozan must be prepared as a water‑based emulsion with a specific concentration to achieve effective tick control inside buildings. The recommended strength for indoor applications is 0.5 % v/v, corresponding to 5 mL of the concentrate per litre of water. This ratio provides sufficient residual activity while limiting toxicity to occupants and non‑target organisms.
Preparation steps
- Measure the required volume of concentrate with a calibrated graduated cylinder; for a 10‑L bucket, add 50 mL of entomozan.
- Fill the container with clean, lukewarm water up to the desired final volume.
- Introduce the concentrate slowly while stirring continuously to ensure uniform dispersion.
- Allow the mixture to stand for 5 minutes to eliminate foam and achieve complete emulsification.
- Transfer the solution to a low‑pressure fogger or spray device calibrated for 100 mL per minute output.
Application guidelines
- Apply the solution to all surfaces where ticks may hide: floorboards, baseboards, cracks, and upholstery.
- Ensure wet coverage of at least 0.2 mL cm⁻²; visual inspection of a test area confirms adequate film formation.
- Maintain a ventilation rate of at least 6 air changes per hour during and after treatment to reduce inhalation exposure.
- Re‑treat the premises after 14 days to interrupt the life cycle of newly emerged ticks.
Safety precautions
- Wear chemical‑resistant gloves, goggles, and a half‑face respirator equipped with a P100 filter.
- Store the concentrate in a locked, temperature‑controlled cabinet; keep it away from foodstuffs and children.
- Record the batch number, dilution ratio, and date of application on a log sheet for traceability.
Following the above protocol yields a consistent dilution that maximizes acaricidal efficacy while adhering to occupational safety standards.