How should Entomozan be diluted for flea control? - briefly
The label recommends diluting Entomozan at 1 ml per 5 L of water for standard flea treatment, and increasing to 1 ml per 2 L for severe infestations; apply the solution evenly to all affected surfaces and let it dry.
How should Entomozan be diluted for flea control? - in detail
Entomozan is a liquid insecticide formulated for flea eradication; the product must be diluted before use to achieve efficacy while preventing toxicity.
The manufacturer recommends a dilution of 0.5 ml of concentrate per 1 liter of water for indoor environments and 1 ml per 1 liter for outdoor infestations. This translates to a 1:2000 ratio for indoor treatment and 1:1000 for outdoor application. Adjust the concentration only if label instructions explicitly allow variations for severe infestations.
Mixing procedure:
- Use lukewarm water (20‑25 °C) to facilitate even dispersion.
- Add the measured concentrate to the water, not the reverse, to avoid splashing.
- Stir gently for 30 seconds until the solution appears uniform; avoid vigorous shaking that can introduce foam.
- Allow the mixture to stand for 5 minutes before spraying to ensure complete solubilization.
Application parameters:
- Indoor: apply 100 ml of solution per 10 m² of floor space, covering carpets, cracks, and pet bedding.
- Outdoor: apply 150 ml per 10 m² of shaded soil, under decks, and around baseboards.
- Spray until the surface is visibly wet but not saturated; excess runoff reduces residual activity.
- Repeat treatment after 7 days, then at 14‑day intervals for three cycles to interrupt the flea life cycle.
Safety precautions:
- Wear chemical‑resistant gloves, goggles, and a respirator rated for aerosols.
- Ensure adequate ventilation; keep pets and humans out of the treated area for at least 2 hours.
- Store the concentrate in a locked, temperature‑controlled cabinet away from foodstuffs.
Common dilution errors:
- Under‑dilution (e.g., <0.5 ml / L) results in insufficient mortality; fleas may persist after the first application.
- Over‑dilution (e.g., >1 ml / L) increases risk of skin irritation and may degrade the active ingredient, lowering effectiveness.
Adhering strictly to the specified ratios, mixing protocol, and application schedule maximizes flea control while maintaining user safety.