How do you wind a thread onto a lice comb? - briefly
Anchor one end of the thread to the comb’s handle, keep it taut, and coil the thread clockwise so it lies evenly along the teeth; then tie the loose end with a tight knot or fasten it with a clip. This method ensures a smooth, uniform winding suitable for precise use.
How do you wind a thread onto a lice comb? - in detail
The process of attaching a thread to a lice comb requires precision and consistency.
Materials: a standard lice comb, a length of thin, non‑elastic thread (cotton or nylon), scissors, and a needle or fine pin for threading.
Procedure:
- Cut a segment of thread approximately 30 cm long; excess length creates slack.
- Hold the comb with the teeth pointing upward; locate the base of the handle where the teeth emerge.
- Insert the needle through the eye of the comb’s handle, pulling the thread until it exits at the opposite side.
- Wrap the free end of the thread tightly around the base of the teeth, completing one full coil.
- Continue coiling in a clockwise direction, maintaining uniform tension after each turn.
- After 5–7 coils, tie a secure knot at the base, leaving a short tail for adjustment.
- Trim any remaining thread beyond the knot; the tail may be tucked under the knot to prevent unraveling.
Tips:
- Apply consistent pressure while winding; uneven tension leads to gaps between coils.
- Use a magnifying glass to verify that each wrap lies flush against the previous one.
- Test the assembled tool by gently pulling the thread; it should resist slipping without excessive rigidity.
Safety considerations: ensure the thread material is free of frays that could snag hair. After each use, rinse the comb and thread with warm, soapy water, then air‑dry. Replace the thread if signs of wear appear.
Following these steps yields a reliable, low‑cost instrument for manual lice removal.