How to properly comb out lice and nits from long hair with a comb? - briefly
«Nit comb» should be used on dry hair; divide the hair into small sections, hold each section close to the scalp and pull the comb down to the ends in a single, steady motion. After each pass, wipe the teeth clean, repeat until no live lice or viable nits are visible, then wash the hair with a pediculicide shampoo.
How to properly comb out lice and nits from long hair with a comb? - in detail
Effective removal of lice and their eggs from long hair requires systematic preparation, precise combing technique, and thorough post‑treatment care.
Begin with a clean environment. Wash hair with a regular shampoo, rinse well, and towel‑dry until damp but not soaking. Apply a lice‑killing conditioner or a designated treatment spray, following product instructions for contact time.
Use a fine‑toothed, metal nit‑comb. Hold the comb at a 45‑degree angle to the scalp, starting at the roots. Drag the comb through a 1‑inch section of hair, moving from scalp outward to the tips. After each pass, wipe the comb on a paper towel or rinse under running water to remove captured insects.
Repeat the process for each section, ensuring overlapping coverage. Perform a second pass on the same section, this time combing from tip to root, to capture any remaining nits that may have shifted.
Complete the combing session by inspecting the hair under good lighting. Look for live lice, nits attached at a ¼‑inch angle from the shaft, or empty shells. If any are found, repeat the combing steps until the hair is clear.
After treatment, wash all combs, brushes, and accessories in hot, soapy water. Launder bedding, clothing, and towels used during the process at temperatures above 130 °F (54 °C). Vacuum carpets and upholstered furniture to remove stray insects.
Schedule follow‑up combing sessions every 2‑3 days for two weeks, as newly hatched lice may emerge after the initial treatment. Maintain this routine until no lice or nits are detected in three consecutive examinations.
Consistent application of the described method eliminates infestation while minimizing the risk of re‑infestation.