How to fasten a flea collar for a cat? - briefly
Open the collar, place it over the cat’s head, and tighten the fastener until it is snug enough to allow two fingers between the collar and the neck, then lock the buckle or clip and trim any excess strap. Verify that the collar stays in place after a few minutes of activity.
How to fasten a flea collar for a cat? - in detail
Secure a flea collar on a cat by following these precise steps.
Select a collar that matches the animal’s weight and size. Most manufacturers list a weight range; choose one that falls within the cat’s current weight. Verify that the collar material is soft, hypoallergenic, and adjustable.
Measure the cat’s neck with a flexible tape, adding approximately one inch (2.5 cm) to allow a comfortable fit. The collar should slide over the head easily but remain snug enough that two fingers can be inserted between the collar and the neck.
Open the clasp or slide mechanism. Place the collar around the cat’s neck, positioning the buckle on the side opposite the cat’s head. Pull the free end through the opening until the collar rests at the measured position.
Fasten the clasp securely. If the collar uses a sliding buckle, slide the adjustable segment until the desired tension is reached, then lock the mechanism. For a snap or hook‑and‑loop closure, ensure the fastener clicks or adheres firmly.
Check the fit by attempting to insert two fingers between the collar and the cat’s skin. If the collar is too tight, loosen it; if too loose, tighten it until the two‑finger test is satisfied.
Trim any excess material if the collar includes a tail or excess strap, taking care not to cut into the fastening mechanism.
Observe the cat for at least 30 minutes after application. Look for signs of discomfort, rubbing, or attempts to remove the collar. Adjust as needed.
Replace the collar according to the product’s recommended schedule, typically every month, or sooner if the cat shows irritation or the collar becomes damaged. Regularly inspect the fastening component for wear and replace the entire collar if any part shows signs of failure.