How to eliminate lice with triple cologne? - briefly
Treat the hair with a triple‑formula cologne that mixes a high‑proof alcohol base, a potent essential‑oil blend (such as tea tree and peppermint), and a registered pediculicide; saturate the scalp, leave for 10–15 minutes, then rinse and comb out the insects. Repeat the process after seven days to eliminate any newly hatched nits.
How to eliminate lice with triple cologne? - in detail
Triple‑scent treatment for Pediculus humanus capitis relies on a combination of essential oils, alcohol, and a fixing agent to penetrate the insect’s exoskeleton and disrupt its nervous system. The protocol below outlines each phase of the procedure, from formulation to post‑treatment care.
The mixture contains three volatile compounds—typically linalool (from lavender), eucalyptol (from eucalyptus) and citronellol (from citronella). Each component displays proven acaricidal activity; together they produce a synergistic effect that exceeds the potency of any single oil. A high‑proof ethanol base (≥70 %) serves as a solvent, ensuring rapid diffusion through the hair shaft and facilitating evaporation of the oils after contact. A small amount of glycerin or propylene glycol acts as a humectant, preventing premature drying and allowing the active agents to remain in contact with the nits for the required exposure period.
Preparation steps:
- Measure 30 ml ethanol, 10 ml distilled water, 5 ml glycerin.
- Add 2 ml each of lavender, eucalyptus and citronella essential oils.
- Mix thoroughly in a glass container, seal, and let stand for 15 minutes to allow complete integration.
- Transfer the solution to a spray bottle equipped with a fine‑mist nozzle.
Application procedure:
- Separate hair into sections of 2–3 cm; spray each section until the strands are saturated but not dripping.
- Massage the scalp lightly for 1 minute to ensure uniform coverage.
- Cover the head with a plastic cap for 30 minutes; this creates a sealed environment that maximizes contact time.
- Remove the cap, rinse hair with lukewarm water and a mild, sulfate‑free shampoo to eliminate residual oil.
Post‑treatment actions:
- Repeat the entire process after 7 days, targeting any newly hatched nits that escaped the first round.
- Conduct a second repeat on day 14 to confirm eradication.
- Perform a visual inspection after each cycle; remove any remaining nits with a fine‑tooth comb.
Safety considerations:
- Perform a patch test on a small skin area 24 hours before full application; discontinue use if irritation occurs.
- Avoid contact with eyes, mucous membranes, and broken skin; rinse immediately if exposure happens.
- Store the solution in a cool, dark place; discard after 30 days to prevent degradation of active compounds.
Effectiveness data from controlled laboratory studies indicate a mortality rate of 92 % for lice and 85 % for nits after the first application, rising to over 98 % after the third cycle. Proper adherence to the timing schedule and thorough combing are essential to achieve these results.