How to dilute agran for fleas? - briefly
Dilute the agran concentrate at roughly 1 ml per liter of water, mixing thoroughly. Apply the solution to the animal’s fur, avoiding eyes and mucous membranes.
How to dilute agran for fleas? - in detail
Agran is a concentrated insecticide intended for treating flea infestations on pets and in environments. Proper dilution ensures efficacy while minimizing toxicity to animals and humans.
First, verify the product label for the recommended concentration. Typical guidance calls for a 0.5 % to 1 % solution, expressed as 5 mL of concentrate per liter of water for a 0.5 % mix, or 10 mL per liter for a 1 % mix. Adjust the ratio according to the severity of the infestation and the sensitivity of the treated area.
Calculate the volume needed for the intended application area. For example, treating a 20‑square‑meter indoor space may require 5 L of solution. At a 0.5 % ratio, mix 250 mL of agran concentrate with 4.75 L of clean water. Use a calibrated measuring cup or graduated cylinder for accuracy.
Prepare the solution as follows:
- Wear disposable gloves and protective eyewear.
- Fill a clean container with the required amount of water.
- Add the measured concentrate slowly, stirring continuously to ensure uniform distribution.
- Do not add water to the concentrate; always add concentrate to water to prevent splashing.
- Allow the mixture to sit for 2–3 minutes before use, as specified on the label.
Apply the diluted spray using a fine‑mist atomizer, covering all surfaces where fleas may reside: bedding, carpets, upholstery, and pet resting spots. Avoid direct contact with the animal’s skin or eyes. After application, keep pets and occupants out of the treated area for the period indicated by the manufacturer, typically 30 minutes to 1 hour.
Dispose of any leftover solution according to local hazardous waste regulations. Do not store the diluted mixture; it loses potency and may become unsafe after 24 hours.
For repeated treatments, follow the recommended interval—usually every 7–10 days—until flea counts are eliminated. Maintain proper ventilation during and after each application to reduce inhalation risk.