How should I properly dilute the product Ciper for tick control? - briefly
Mix 1 ml of «Ciper» concentrate with 1 liter of water to obtain a 0.1 % solution appropriate for tick control. Apply the mixture evenly to the target area, observing all label safety guidelines.
How should I properly dilute the product Ciper for tick control? - in detail
Dilution of Ciper for tick control must follow label specifications and safety guidelines.
Begin with label verification. Identify the recommended concentration for the target tick species, the type of surface (ground, vegetation, or livestock), and the intended treatment area size.
Prepare the mixing solution:
- Use clean, potable water at ambient temperature (15‑25 °C).
- Measure the exact volume of water required for the planned area, following the label’s dosage chart (e.g., ml of concentrate per L of water).
- Add the measured amount of Ciper concentrate to the water gradually, stirring continuously to ensure uniform distribution.
After mixing, allow the solution to stand for the period indicated on the label (typically 5–10 minutes) to achieve complete dissolution.
Application guidelines:
- Load the prepared solution into a calibrated spray device.
- Adjust the nozzle to produce a fine, even mist covering the target surface without excessive runoff.
- Apply at the recommended rate, expressed as L per 100 m² or equivalent, to achieve the target concentration on the substrate.
Safety and handling:
- Wear protective gloves, goggles, and an impermeable suit during preparation and application.
- Avoid direct skin contact and inhalation of aerosols.
- Keep the mixture away from food, feed, and water sources.
- Store any remaining concentrate in its original, tightly sealed container, away from heat and sunlight.
Cleaning procedures:
- Rinse all equipment with water after use, then with a mild detergent solution.
- Dispose of rinse water according to local hazardous waste regulations.
Record keeping:
- Document the date, location, weather conditions, concentration used, and volume applied.
- Retain records for the duration required by regulatory authorities.
Following these steps ensures the product is diluted correctly, maximizes efficacy against ticks, and minimizes environmental and health risks.