How should a wormwood collar for fleas and ticks be put on? - briefly
Place the collar around the animal’s neck, adjust it so it sits two finger‑widths above the skin, and trim any excess length. Ensure the fit is snug but not restrictive, and replace it according to the manufacturer’s recommended interval.
How should a wormwood collar for fleas and ticks be put on? - in detail
Begin by selecting a collar sized for the animal’s neck circumference. Measure the neck with a flexible tape, add 1‑2 cm to allow a snug but not restrictive fit. Verify that the wormwood collar you have matches this measurement; most products list a range (e.g., 30‑45 cm).
Lay the collar flat on a clean surface. Identify the adjustable buckle or Velcro closure and the inner side that contacts the skin. If the collar includes a plastic safety release, familiarize yourself with its location before application.
Place the collar behind the animal’s head, sliding it forward until the opening rests against the throat. Pull the ends evenly until the collar encircles the neck. Secure the fastener, ensuring the band sits two finger‑widths from the skin. Tightening beyond this point can impede breathing and circulation; loosening too much reduces efficacy.
After fastening, inspect the collar for gaps or twists. The wormwood‑infused material should be in continuous contact with the skin along the entire circumference. Adjust as needed to eliminate any protruding edges.
Monitor the pet for the first 24 hours. Observe for signs of irritation, excessive scratching, or difficulty swallowing. If discomfort persists, remove the collar, re‑measure the neck, and select a correctly sized alternative.
Replace the collar according to the manufacturer’s schedule, typically every 4–6 weeks, or sooner if the scent diminishes. Store the unused portion in a cool, dry place to preserve the active compounds.