How is chemerich water used for fleas? - briefly
Chemerich water is applied directly to the pet’s fur or sprayed onto bedding, where its chemerin‑derived compounds interfere with flea sensory receptors, leading to swift death. Repeating the treatment weekly interrupts the flea life cycle and prevents re‑infestation.
How is chemerich water used for fleas? - in detail
Chemerich water, a diluted solution of the natural compound chemerin, is applied directly to environments and animals infested with fleas to disrupt the insects’ life cycle. The active ingredient interferes with flea sensory receptors, causing disorientation and mortality.
The typical procedure involves the following steps:
- Preparation: Mix the commercial concentrate with clean water according to the manufacturer’s ratio, usually 1 ml of concentrate per liter of water. Ensure thorough agitation to achieve a homogeneous solution.
- Application to bedding and carpets: Spray the solution evenly onto pet bedding, carpets, and floor mats. Allow the surface to remain wet for at least 15 minutes before vacuuming or washing, ensuring fleas and larvae absorb the agent.
- Direct treatment of pets: Dilute the solution to a lower concentration (often 0.5 ml per liter) and apply with a fine mist to the animal’s coat, avoiding the eyes and mucous membranes. Repeat the misting every 48 hours for three treatments to cover the complete flea development cycle.
- Outdoor treatment: For yards or kennels, use a garden sprayer to cover shaded areas, underbrush, and resting spots. Apply during the early morning or late evening when temperature is below 25 °C to maximize stability of the active compound.
- Safety checks: Verify that the treated surfaces are dry before allowing pets or humans to re-enter the area. Store any unused solution in a sealed container away from direct sunlight.
Effectiveness relies on maintaining the recommended exposure interval. Flea eggs hatch within 24–48 hours; larvae develop over 5–7 days, and adults emerge after another 2–3 days. By re‑applying the solution at 48‑hour intervals, each generation encounters the chemerin compound before reaching reproductive maturity, leading to a rapid decline in the population.
Monitoring should include weekly inspection of pet fur and the environment for live fleas. If counts remain above a threshold after two weeks, increase application frequency to every 24 hours for an additional three‑day cycle, then revert to the standard schedule.
Proper disposal of contaminated water follows local regulations; usually, it can be poured down the drain with ample flushing water, as chemerin degrades quickly in wastewater treatment systems.