How can you prepare entomozan for treating premises against fleas? - briefly
Dissolve the specified amount of entomozan (for example, 1 g per 10 L of warm water) until completely mixed, then transfer the solution to a spray container. Apply it evenly to floors, baseboards, cracks and other flea‑harboring sites, allowing it to dry before re‑entering the premises.
How can you prepare entomozan for treating premises against fleas? - in detail
To formulate a flea‑control solution with entomozan, follow these precise steps.
First, verify that the product label authorizes use in the intended environment (homes, warehouses, animal shelters). Confirm the concentration recommended for indoor application and note any restrictions on temperature or humidity.
Gather the required equipment: a calibrated measuring cylinder, a clean mixing container resistant to chemicals, a stir rod or mechanical agitator, protective gloves, goggles, and a respirator if the label advises respiratory protection. Ensure the work area is well‑ventilated.
Measure the active ingredient according to the label‑specified ratio, typically expressed as milliliters of concentrate per liter of water. For example, a common guideline may require 10 ml of entomozan per 5 L of water to achieve a 0.2 % solution. Use the measuring cylinder to obtain the exact volume, then pour the concentrate into the mixing container.
Add the measured amount of water to the container. Stir continuously until the solution becomes homogenous; this usually takes 30–60 seconds with manual agitation or a few seconds with a mechanical mixer. Avoid splashing; any residue on surfaces should be wiped away with a disposable cloth.
After mixing, inspect the solution for clarity. Cloudiness or sediment indicates incomplete dissolution and requires additional stirring. Once the mixture is clear, transfer it to a sprayer or fogger designed for indoor pesticide application. Calibrate the device according to the manufacturer’s instructions to deliver the correct dosage per square meter.
Apply the solution uniformly across all floor surfaces, baseboards, cracks, and crevices where fleas may hide. Maintain a wet film for the contact time stipulated on the label, typically 10–15 minutes, before allowing the area to dry. Repeat treatment according to the recommended schedule, often every 7–14 days, until flea activity ceases.
Dispose of any unused solution and empty containers in accordance with local hazardous waste regulations. Rinse all equipment with water and store it separately from food‑grade items.
Record the preparation date, concentration, and application locations for future reference and regulatory compliance.